Fold Adjustment
Problem
The fold on the output is not correct or as desired.
Tip:
The Fold Adjustment Profile is available only when the system configuration includes a finishing device with a booklet maker or the C/Z Folder.
Solutions
For detailed information about these finishing devices, refer to
Finishing Devices.
Create or use an existing Fold Adjustment Profile.
Before creating a new or using an existing profile or performing any alignment adjustments, read/review the entire
Fold Adjustments section in the
PredictPrint Media Manager.
• Depending on your system configuration, the following fold adjustments are available:
• Bi-Fold Single Sheet (available only with the PR Booklet Maker Finisher)
• Bi-Fold Multiple Sheets (available only with the PR Booklet Maker Finisher)
• Bi-Fold Multiple Sheets Stapled (available only with the PR Booklet Maker Finisher)
• C-Fold (available with the optional C/Z Folder)
• Z-Fold (available with the optional C/Z Folder)
• Z-Fold Half-Sheet (available with the optional C/Z Folder)
Create a new or use an existing Fold Adjustment Profile. The following steps are required for creating a new or using an existing procedure.
Note:This option is accessed from > > .
1. From the PredictPrint Media Manager main screen, select Profiles.
2. Select the Fold Adjustment tab.
3. Select New or Edit.
If you edit an existing fold adjustment, select the desired profile from the list and then select Edit.
4. Type in a new name or, if desired, edit the existing name.
5. To complete the procedure, refer to
Fold Adjustment Procedures. Select the desired fold adjustment procedure and complete the procedure for creating a new or editing an existing
Fold Adjustment Profile.