SquareFold® Trimmer Paper Path
Number | Description |
|---|---|
1 | The booklet leaves the booklet area of the finisher and enters the SquareFold® Trimmer device. The booklet exit sensor, in the SquareFold® Trimmer device, detects the lead-edge spine of the booklet and moves the booklet to the square-fold area. |
2 | Once the booklet spine reaches the square-fold area, the booklet is clamped and the square-folding operation begins. |
3 | The booklet is flattened and the spine squared according to the square-fold setting indicated on the control panel. |
4 | After the booklet is flattened and the spine squared, it is moved to the trimmer area. • Based on the finished booklet size, the booklet is moved until the trail edge reaches the trimmer cutter. • The trail edge is trimmed (cut); this is based on the finished booklet size entered for the trimmer mode setting. |
5 | The booklet is then moved to the exit area where it is transported to the booklet tray. |
Note: Booklets exiting the SquareFold® Trimmer device may contain trim remnants or scraps from the previously trimmed booklet. This is due to static electricity build-up and is normal. If booklets contain trim remnants or scraps, simply remove and discard them.