Top Tray
If output sheets are not fully ejected, this causes the press to detect a Paper Full condition. If this condition is detected frequently, change the angle of the top tray.
Refer to the following guidelines for changing the top tray angle:
• For normal usage, keep the tray in its lower, default position.
Important:
Continual usage of the tray in the upper position, may cause paper jams or output sheets to fall from the tray upon delivery.
Continual usage of the tray in the upper position, may cause paper jams or output sheets to fall from the tray upon delivery.
• When using the following paper types, change the angle of the tray to its upper position. These paper types may cause frequent Paper Full conditions:
• Light-weight (106 g/m2 or lighter) coated paper
• Coated paper whose edges are 364 mm or longer
• Long paper
Note: If sheets are curled, changing the tray angle has no effect.
A | B |
|---|---|
Default, lower angle  | Raised, upper angle  |
To change the angle of the tray:
1. Pull the top tray from the lower seating (A) by pulling it toward the right.
2. Insert the clutches at the lead edge of the tray into upper seating (B).