Performing the Clean Toner Procedure
Important:
The following procedure is performed only by a person who has press administrator privileges and is logged onto the press as administrator. Non-administrator users must contact an administrator in order to to complete this procedure.
Use the Clean Toner procedure after running a low area coverage job followed by large area coverage job, which caused toner agglomerates and clumps on the output prints. The press runs a full-page halftone to purge the debris and any residual dry ink/toner from the system.
Note: It is recommended that you run a few test prints before performing the cleaning procedure. After the Start Cleaning button is selected, the system automatically generates a test print. This allows you to compare the before and after prints for image quality.
1. At the press control panel, log in as the administrator.
2. Press the Machine Status button.
3. Select the Tools tab.
4. Select System Settings > Common Service Settings > Maintenance.
5. Scroll through the Maintenance pages and select Clean Toner.
6. Select the desired dry ink/toner colors to clean.
If desired, you can select all the toner colors.
7. Press Start.
After the purge page prints, a Successfully Completed message appears.
8. To ensure that the problem is resolved, select Sample Print.
9. Select Close repeatedly until the main Tools screen appears.
10. Exit the administrator mode.