Cleaning the Fuser Assembly with Paper
Note: If you still notice contaminants on the back of the prints after running this procedure, contact your Xerox Service Representative. Dry ink/toner debris may be coming from the transfer roll area instead of the fuser.
1. Select the Tools button on the press control panel.
2. Select Clean Fuser Assembly.
3. For Paper Supply, select the paper tray to use.
Note: Any type of paper and size can be used. However, the smooth surface of coated paper does offer more contact area to the pressure roll.
4. For Number of Sheets, select the number of blank sheets to print (1 to 5).
Note: For best results, run fewer sheets for a multiple number of times. It is more effective to run one or two sheets for multiple times than to run five sheets for one time only. This is especially important when running larger sheets, in the short-edge-feed (SEF) direction, such as 11 x 17 in. or A4 paper.
5. Select Save.
6. Press the Start button.
The system begins the cleaning process.
Note: When running five sheets of paper, the process takes approximately one minute.
When the cleaning process is finished, a Completed Successfully message displays.
7. Select OK.