Replacing the Tray 5 Feed Rolls
To perform this procedure, the feed roll kit is required. The kit contains all the required items for replacing the feed rolls.
Tip:
Perform the following procedure when Tray 5 is installed on top of Trays 8 and 9.
Perform the following procedure when Tray 5 is installed on top of Trays 8 and 9.
Replace the feed rolls for Tray 5 (Bypass) when experiencing frequent multifeeds, single feeds, or blank prints in the stack of the output prints.
1. Feed Roll
2. Nudger Roll
3. Separator Roll
1. Locate Tray 5 (Bypass) on top of Trays 8 and 9.
2. Lift up and open the bypass tray cover to access the feed roll components.
3. Remove the feed roll and install a new one.
a. Remove the feed roll by squeezing the metal shaft at both ends and lifting it up and out of the tray.
b. Install a new feed roll by squeezing the metal shaft at both ends and sliding it into place.
4. Remove the nudger roll and install a new one.
a. Remove the nudger roll by squeezing the metal shaft at both ends and lifting it up and out of the tray.
b. Install a new nudger roll by squeezing the metal shaft at both ends and sliding it into place.
5. Remove the separator roll and install a new one.
a. Remove the separator roll by squeezing the metal shaft at both ends and lifting it up and out of the tray.
b. Install a new separator roll by squeezing the metal shaft at both ends and sliding it into place.
6. Close the bypass tray cover.
7. Verify that the tray is operating correctly by feeding paper from the bypass tray.
8. Log in as the administrator or ask the administrator to perform the following steps to reset the High Frequency Service Item (HFSI) count to zero (0):
a. At the control panel, press the Tools button.
b. From the screen that displays, select the Tools icon.
c. Select > > .
d. Use the up / down arrow buttons to access the next Maintenance screens.
e. Select the Technical Key Operator icon. The Technical Key Operator feature displays.
f. Select the bypass roll items that corresponds with the newly-replaced components.
g. Select Reset Current Value. The system resets the High Frequency Service Item (HFSI) to 0.
h. Exit the administrator mode by pressing the Log In / Out button on the control panel. When prompted, select Logout.