Versant4100_Doc : Working With : PredictPrint Media Manager : Advanced Stock Setup : Creating or Modifying Advanced Stock Setup Options
Creating or Modifying Advanced Stock Setup Options
1. Perform one of the following:
•Copy an existing stock entry. Refer to Copying a Stock Entry.
•Modify or edit an existing stock entry. Refer to Editing an Existing Stock in the Stock Library.
2. From the Stock Properties window, select and modify the stock attributes as required, including entering a new or revised stock name, selecting a stock size, color, and other attributes.
3. Select the Advanced Setup button.
The Advanced Stock Setup window opens.
4. From the Advanced Stock Setup window, select the various options as required.
For information, refer to Advanced Stock Setup Options.
Advanced Stock Setup options include the following:
•Stock By Name Only
•Multifeed Detection
•Tray Air Assist
•Enable Tray Heater
•Aligner Roll Pressure
•Regi-Loop
•Pre Gate Roll Adjustment
•Primary Transfer Current Adjustment
•Secondary Transfer Voltage Adjustment
For more information, refer to Secondary Transfer Voltage Adjustment.
•Transfer output adjustment for trail edge
•Adjustment of Paper Speed at Transfer
•Fuser Temperature Adjustment
•Fuser Speed Adjustment
•Alignment Profile
For detailed information and instructions, refer to Alignment Profiles.
•Fold Adjustment Profile
For detailed information and instructions, refer to Fold Adjustments.
•Paper Curl Correction
For detailed information and instructions, refer to Correcting the Paper Curl.
5. Run test prints to ensure that the selected options provide the desired output.
•If the test prints are acceptable, continue to the next step.
•If the test prints are not acceptable, repeat the previous steps and run more test prints until the desired printed output is achieved. If the output continues to be unacceptable after multiple sets of test prints, contact your Customer Support Center for further assistance.
6. To save selections and close the Advanced Stock Setup window, select OK.
7. To save and close the Stock Properties window, select OK.