Interface Decurler Module Curl Correction
Tip:
The purpose of this curl correction is to fix paper curl as it leaves the press but before it reaches the next inline-finishing device. Use the IDM curl correction feature while the press is printing.
The purpose of this curl correction is to fix paper curl as it leaves the press but before it reaches the next inline-finishing device. Use the IDM curl correction feature while the press is printing.
1. Printed Media from the Press
2. Interface Decurler Module paper path
3. Printed media from the Interface Decurler Module to inline finishing device
As media enters the module, it is fed to the IDM decurler for paper curl correction. The IDM decurler has both upper and lower decurler rolls that apply pressure to the media based upon the following:
• System default (Auto on)
• Manual selections made from the IDM control panel
If you want to adjust the paper curl on the printed output quickly and at the point-of-need, use the manual curl up or down buttons. If the printed output contains too much curl after using these buttons, refer to Advanced Stock Setup and Correcting the Paper Curl.
From the IDM decurler, the print media is cooled and routed from the IDM to the optional finishing device that is next inline and connected to the press.