Fuser Maintenance Kit
Replacing the Fuser
When it is time to replace the fuser, the printer displays a message on the control panel.
To replace the fuser:
*CAUTION: Do not perform this procedure when the printer is copying or printing.
1. Turn off the printer, then unplug the power cord from the electrical outlet.
Turning off the printer and removing the power cord
2. Open Door C and wait for the printer to cool for 30 minutes.
Opening Door C
*Hot Warning: The inside of the printer might be hot. To reduce the risk of injury from a hot component, allow the surface to cool before touching it.
3. To unlock the fuser, rotate both the knobs counterclockwise until the knobs spring forward.
Explains the procedure to unlock the fuser
4. Remove the fuser unit from the printer.
Removing the fuser unit
5. Unpack and insert the new fuser unit into the printer until it clicks into place.
Unpacking the fuser unitInserting the fuser unit
6. To lock the fuser, rotate both the knobs clockwise until it is tight.
Explains the procedure to lock the fuser unit
7. Close Door C.
Closing Door C
8. Connect the power cord to the electrical outlet, then turn on the printer.
Connecting the power cord and turning on the printer
*Potential Injury: To avoid the risk of fire or electrical shock, connect the power cord to an appropriately rated and properly grounded electrical outlet that is near the product and easily accessible.
9. Dispose the used fuser unit.
Disposing the used fuser unit